Balboa 500z Series Manual

Balboa 500z Series Manual 8,7/10 3754votes

download free shareit terbaru

Balboa 500z Series PartsBalboa 500z Series Manual

Temp Jets Blower Light Temp Control (80°F - 104°F / 26°C - 40°C) The last measured water temperature is constantly displayed. The water temperature displayed is current only when the pump has been running for at least 2 minutes. On panels with a single “Temp” or “Set” button, to display the set temperature, press the button once.

Buy Balboa product direct on Balboa Direct. Balboa Direct Manuals & Instructions. Caged Freedom Series Instructions. Balboa 500Z-Series Operation Guide This document covers VS and GS systems 500Z through 521Z with Balboa Panels VL200. Follow all owner’s manual power connection. Balboa Water Group 500Z-Series User Manual • Diagnostic messages • Balboa Water Group Control panel. Troubleshooting & Service for GL/GS Systems. Balboa Service Tools Checklist. 500Z Series Panel. Balboa 500Z-Series Operation Guide This document covers VS and GS systems 500Z through 521Z with Balboa Panels VL200. Follow all owner’s manual power connection.

Balboa Hot Tub Troubleshooting

To change the set temperature, press the button a second time before the display stops flashing. Each press of the button will continue to either raise or lower the set temperature.

If the opposite direction is desired, allow the display to revert to the current water temperature. Press the button to display the set temperature, and again to make the temperature change in the desired direction. On panels with “Warm” and “Cool” buttons, to display the set temperature, press “Warm” or “Cool” once. To change the set temperature, press a temperature button again before the display stops flashing.

Each press of “Warm” or “Cool” will adjust the set temperature. After three seconds, the display will stop flashing and begin to display the current spa temperature.

2017 Hino Truck Owners Manual. Jets 1 Press “Jets 1” to turn pump 1 on or off, and to shift between low and high speeds (if equipped). The low-speed will turn off after 4 hours. High-speed will turn off after 15 minutes. Low-speed may run automatically at times, during which it cannot be deactivated from the panel, but high-speed may be operated. Jets 2/Jets 3/Blower (If equipped) Press the corresponding button once to turn the device on or off. The device will turn off after 15 minutes. Pump 2 may be two-speed on some systems.

Some systems use this one button to control two devices. The first button press will activate one device. Press again to have both devices active. Press again to turn off the first device only.

Press one more time to turn both devices off. Initial Start-up Your spa will enter Priming Mode ( ) when it is energized.

During Priming Mode, press “Jets” button(s) repeatedly and be sure all pumps are free of air. Priming Mode lasts less than 5 minutes.